How to do it? iREMOVAL PRO BYPASS V3 DETAILED EXPLANATION

[Filesupport]

iRemoval Pro Premium User Manual (V3.1.1)​

1. Download the latest version of the tool and delete the old version:
   
   • Always make sure you're using the latest version.
2. Equipment Preparation:
   
   • Do not connect the iPhone to WiFi.
   • Prepare your computer:
     • Your computer must have Windows 10 or a later version.
     • Use a proper USB cable and a fast internet connection (preferably WiFi, but not a mobile hotspot).
     • Your iPhone should have at least 40% battery charge.
3. Restore iPhone Software:
   
   • Quickly restore your iOS version to 17.7 or 18.0.1.
   • Disable Test Mode and Driver Signature Enforcement in Windows:
     • Disabling Test Mode: When Windows is in test mode, a watermark appears in the lower right corner of the screen. You can follow online guides (on Dell or similar sites) to disable this mode.
     • Disabling Driver Signature Requirements: This process might be slightly different in Windows 11; you can refer to the guides for more information.
4. BIOS Settings:
   
   • If you receive the warning "The value is protected by the secure boot policy" in the command prompt, you need to disable secure boot via the BIOS.
5. Prepare your PC drivers:
   
   • Uninstall iTunes: Remove iTunes from the 3uTools toolbox and restart your computer.
   • Reinstall iTunes: Reinstall iTunes from the same toolbox and restart your computer.
   • Run Driver Repair: In the 3uTools tool, go to the “Advanced Repair” option, remove the old drivers, and disable the firewall.
6. Activating Using the Tool:
   
   • Turn on iRemoval Pro and connect the device without a SIM card or WiFi connection.
   • Initiate the "Activation" process; it will most likely be successful.

Possible Error Messages and Solutions​

1. If activation fails: Your internet connection may be slow or unstable.
2. If the device shuts down when an iPhone or iPad is connected: This is usually due to a firewall issue. You can resolve firewall problems by downloading and running the CloudWarp application.
3. The 0xF Error and Signal Problem: This error is common. You can resolve it by following these simple steps:
   
   • Restore your iPhone to iOS 17.7 or 18.0.1.
   • Open the iRemoval Pro tool and connect the device without a SIM card or WiFi.
   • Activate the software, and if you receive an error, turn on your WiFi and try again.