[Hardware] Redmi K70 Pro (manet) EDL 9008 Test Point | Unbrick & Flashing Pinout​

Device Specifications & Hardware Details:

• Device Model: Redmi K70 Pro
• Device Codename: manet
• Processor / Platform: Qualcomm Snapdragon 8 Gen 3 (SM8650-AB, 4nm)
• Storage Type: UFS 4.0
• Operating System: Xiaomi HyperOS (Android 14 / Android 15)
• Function: Hardware Emergency Download Mode (EDL / Qualcomm HS-USB QDLoader 9008)

Hardware Test Point Location & Procedure​

The EDL test points on the Redmi K70 Pro (manet) motherboard are two gold contact pads located on the main logic board (near the motherboard shielding cans and sub-ribbon connector / battery socket).

[ Motherboard PCB - Top View ]<br> +---------------------------------------+<br> | [Camera Cutouts] |<br> | |<br> | +-------------+ |<br> | | Shield | o o &lt;--- [EDL TP]|<br> | | (SM8650) | (TP1) (GND/TP2) |<br> | +-------------+ |<br> | [Battery FPC] |<br> +---------------------------------------+<br>

Step-by-Step Connection Guide:​

1. Power Off & Disassemble: Gently heat the back glass panel, lift it carefully, and remove the plastic protective bracket/cooling film covering the motherboard.
2. Disconnect Battery: Detach the battery flex cable (FPC) from the motherboard to avoid short-circuiting live rails.
3. Bridge the Test Points: Using fine-point conductive tweezers, short the two dedicated test point pads together (or short the primary test point pad directly to PCB Ground/Shielding).
4. Plug USB Cable: While holding the short, plug a certified USB Type-C cable connected to your PC.
5. Release & Verify: Hold the tweezers on the test points for 2–3 seconds, then release. Check Windows Device Manager:
   
   • Under Ports (COM & LPT), the port should identify as:
     
     Qualcomm HS-USB QDLoader 9008 (COMxx)

Key Applications & Use Cases:​

1. Dead Boot / Hard Brick Repair: Recover devices showing a black screen, no fastboot, no vibration, drawing low current (0.01A–0.05A) on a DC power supply.
2. Authorized Mi Flash Recovery: Force 9008 mode for EDL flashing with authorized Xiaomi accounts or patched Firehose loaders.
3. Corrupted Partition Recovery: Fix corrupted xbl, abl, or partition table failures that prevent the phone from booting into Fastboot or Recovery modes.

Important Service Notes:

• Snapdragon 8 Gen 3 platforms enforce strict Qualcomm Secure Boot and Xiaomi server-side authorization. Flashing via EDL 9008 requires an authorized Xiaomi service account or a valid signed authentication token.
• Always disconnect the battery before applying tweezers to prevent damaging motherboard power rails.

Click to expand...